TM 5-3825-213-35
292.
Front and Rear Service Brake and Slack
NOTE
Adjuster Assembly Cleaning, Inspection, and
PIN (5) SECURES WORM (9) TO
Repair
SHAFT (6).
a.
Cleaning.
(1) Clean all metal parts, except brake linings,
with approved cleaning solvent and dry
thoroughly.
(2) Inspect the linings for cracks, grooving, or
excessive wear.
Replace badly worn
linings or linings that have been grease-
soaked.
(3) Inspect the brake hose for cracks or breaks.
(4) Inspect the cam rollers for scuffing,
cracking, or wear.
(5) Inspect the camshaft for bending or
cracking. Replace a damaged shaft.
(6) Inspect all other parts for defective
condition.
Replace or repair a worn,
1
Rivet, solid (5 rqr)
damaged, or defective part.
2
Body cove
3
Worm gear cover
4
Expansion plug
293.
Front and Rear Service Brake and Slack
5
Pin, special
Adjuster Assembly Reassembly and
6
Worm gear shaft
Installation
7
Plunger lock spring
8
Locking plunger
a. Reassembly. Reassemble the slack adjuster in
9
Drive gear worm
reverse of numerical sequence illustrated on figure 88.
10
Worm gear
11
Sleeve bearing (2 rqr)
b. Installation.
12
Plug, pipe, 1/827
(1) Install the front and rear service brake and
13
Slack adjuster body
slack adjuster assembly as instructed on
Figure 88. Front and rear service brake slack
(2) Install
the
wheel
assembly
(TM
adjuster assembly, disassembly and reassembly,
5382521320).
exploded view.
Section IX. CARRIER MAIN AND OVERLOAD SPRING ASSEMBLY
295.
Carrier Main and Overload Spring Assembly
294. General
Removal and Disassembly
The spring assembly consists of two groups of springs;
a. Removal.
the main spring and overload springs. The overload
(1)
Block and support the carrier frame and
springs consists of six leaves mounted on top of the main
wheels.
spring leaves. The main spring ends are attached to a
hanger which is mounted to the carrier frame. The
centers of the springs are mounted to the axle with two
spring clips, nuts, and lockwashers.
213