TM 5-3825-213-35
Section X. CARRIER CHASSIS WIRING HARNESS
298. General
c. Repair. If break in wire is exposed and is readily
Electrical components of the carrier chassis
are
accessible, shave away insulation on wire to expose one-
connected in the proper circuit by a wiring harness.
half inch of bare wire at both ends of break. Twist bare
wires together and solder the connections.
Cover
299.
Carrier Chassis Wiring Harness Removal
repaired cut by wrapping electrical tape over entire area.
Do not leave any bare wire exposed.
For removal of the wiring harness refer to wiring
d. Replacement. If the break in a wire is not readily
diagram (TM 5-3825-213-20).
accessible and cannot be repaired, replace wire by
disconnecting it at both ends of component, or
300.
Carrier Chassis Wiring Harness Inspection,
components, and remove. Install a new wire and connect
Testing, Repair, and Replacement
both ends to components. If a wire is part of wiring
harness and is defective, disconnect both ends and cover
a. Inspection. Inspect insulation for cracked or
these ends with electrical tape. Install a new wire of the
same size and attach it to outside of wiring harness.
frayed material. Pay particular attention to wires passing
through holes in frame and over rough edges.
If
inspection reveals a broken or cut wire, and break in wire
Note
is exposed and readily accessible, wire must be repaired
Be sure to identify new wire with same
or replaced.
identification number as one removed.
301. Carrier Chassis Wiring Harness Installation
b. Testing. Test for continuity by disconnecting
each end of wire from component to which it is attached.
For installation of the wiring harness refer to wiring
Refer to TM 5-3825-21320 for wiring diagram. Touch
diagram (TM 5-3825-213-20).
probes of a test lamp to each end of wire. If lamp does
not light, wire is defective. Repair or replace a defective
wire.
Section XI. CARRIER CAB, WINDOWS, AND WINDSHIELD ASSEMBLY
302. General
(3) Remove the plow hydraulic manifold (TM 5-
3825-213-20).
The carrier cab assembly consists of the panels, frame,
(4) Tag and disconnect instrument panel wiring
doors, floor mats, windshield, side and rear windows. The
(TM 5-3825-213-20).
cab serves as the housing for the operating controls,
(5) Tag and disconnect air and hydraulic lines
instruments, and gages and provides protection against
(TM 5-3825-213-20).
the weather for the operator.
(6) Disconnect priming aid levers (TM 5-3825-
213-20).
(7) Remove the steering wheel (par. 279).
303. Carrier Cab, Windows and Windshield Assembly
(8) Remove carrier cab doors (TM 5-3825-213-
Removal
20).
(9) Remove heater ducts (TM 5-3825-213-20).
a. Carrier Cab Removal.
(10) Remove the operator's seat (TM 5-3825-
(1) Remove the lights and horn assemblies
213-20).
(TM 5-3825-213-20).
(11) Remove the carrier cab as instructed on
(2) Remove the defroster manifold and tubes
(TM 5-3825-213-20).
216
