TM 5-3825-213-35
Figure 86. Ring and pinion gear adjustment pattern.
(2) Install the drive shaft (TM 5--3825-213-20).
reading of 16 to 20 inch-pounds is
indicated. This reading will be equivalent to
(3) Install the ball joint assemblies (par.285).
25 to 50 inch-pound bearing preload.
(4) Fill the differential (LO 5-3825-213-20).
b. Installation.
(1) Install the front or rear axle housing and
carrier assemblies as instructed on figure
Section VIII. FRONT AND REAR SERVICE BRAKES AND SLACK ADJUSTERS
290. General
depresses the diaphragm, push rod, and slack adjuster
Located at each of the four wheels are wheel brake
into a downward position. This, in turn, rotates the cam
assemblies. They are composed of two brake shoes
and delivers the pressure to the shoes against the brake
pivoted on anchor pins, a brake c-am, and brake shoe
drums. When the air pressure is release, the brake shoe
retracting spring. When the brakes are applied air
return spring
pressure is admitted into the air chamber, which
210