TM 5-3825-213-35
1
Nut, 7/814 (8 rqr)
17
Bearing cup (2 rqr)
2
Washer, lock, 7/8 in. (8 rqr)
18
Bearing cone (2 rqr)
3
Bearing cap (2 rqr)
19
Washer, trunnion grease retainer (2 rqr)
4
Shim (as rqr)
20
Bearing cup (2 rqr)
5
Nut, 7/814 (8 rqr)
21
Bearing cone (2 rqr)
6
Washer, lock, 7/8 in. (8 rqr)
22
Washer, trunnion grease retainer (2 rqr)
7
Arm
23
Felt (2 rqr)
8
Arm
24
Felt (2 rqr)
9
Shim (as rqr)
25
Screw, cap, 5/811 x 3 1/4 in. (2 rqr)
10
Nut, 3/410 (8 rqr)
26
Nut, 5/811 x 3 1/8 in. (2 rqr)
11
Washer, lock, 3/4 in. (8 rqr)
27
Stud, 7/8-14 x 3 1/8 in. (2 rqr)
12
Screw, cap, 3/410 x 5 in. (8 rqr)
28
Stud, 7/814 x 4 1/4 in. (2 rqr)
13
Ball
29
Stud, 7/814 x 3 1/4 in. (4 rqr)
14
Seal
30
Lower socket
15
Fitting, lubrication
31
Upper socket
16
Bearing
B. Front and rear socket and ball assembly, exploded view.
Figure 83-Continued.
(1) Install the front or rear ball joint assembly as
(3) Inspect the axle shaft for breaks, chipped
instructed on figure 82.
splines, and worn bushings.
(2) Install the front or rear axle and skein assembly
(4) Inspect the bearings for pits, breaks, and free
as instructed on figure 81.
movement.
(3) Install the service brake and slack adjuster
(5) Repair or replace defective parts as necessary.
assembly (par. 293).
(4) Install the air brake chamber (TM 5 3825-213-
285.
Front and Rear Ball Joint Suspension
20).
Assembly Reassembly and Installation
(5) Install the wheel and hub (TM 5 3825-213-20).
a. Reassembly. Reassemble the axle and ball
joint assembly in reverse of numerical sequence
(6) Install the tie-rod steering cylinder and control
illustrated on figure 83.
valve (TM 5-3825-213-20).
b. Installation.
(7) Adjust the toe-in (TM 5-3825-213-20).
Section VII. FRONT AND REAR AXLE HOUSING AND DIFFERENTIAL ASSEMBLY
bearing behind the pinion gear teeth to carry the radial
286. General
load.
The front and rear axle and differential are
driven by means of propeller shafts from the transfer
case. The front and rear axle gear ratio is 6.167: 1.
287. Front and Rear Axle Housing and Differential
The differential and gear assembly is mounted on
Assembly Removal and Disassembly
tapered roller bearing. The straddle mounted pinion has
a. Removal.
two tapered roller bearings in front of the pinion teeth
(1) Drain the differential (LO 5-3825 213-20).
that take the forward and reverse thrust and a third
206
