TM 5-3825-213-35
1
Nut, special
21
Spring
2
Washer, lock, 1 1/8 in.
22
Seat
3
Steering arm
23
Bearing
4
Screw, cap, 3/824 x 1 1/2 in.
24
Screw-, cap, 3/8-16 x 1 in. (4 rqr)
5
Screw, cap, 3/824 x 1 1/4 in. (2 rqr)
25
Washer, lock, 3/8 in. (4 rqr)
6
Washer, lock, 3/8 in. (2 rqr)
26
Cover
7
Mounting bracket
27
Shim
8
Nut
28
Tube
9
Adjusting screw
29
Cam and shaft tube
10
Screw, cap, 5/911 x 3/4 in. (2 rqr)
30
Ring, retaining
11
Nut, 5/811
31
Bearing
12
Screw, cap, 3/816 x 1 1/2 in. (4 rqr)
32
Ring, retaining
13
Washer, lock, 3/8 in. (4 rqr)
33
Bearing
14
Side cover
34
Seal
15
Gasket
35
Bushing
16
Lever shaft
36
Bushing
17
Nut, special (2 rqr)
37
Plug, pipe (3 rqr)
18
Washer, special (2 rqr)
38
Cover end
19
Bearing (2 rqr)
39
Housing
20
Stud (2 rqr)
Figure 80-Continued.
Section VI. FRONT AND REAR BALL JOINT SUSPENSION ASSEMBLY
282. General
Note.
The front and rear ball joints are identical in
parts and mounting. These serve as axle steering
Remove the opposite ball
joint
knuckles with trunnion bearings mounted in the ball and
assembly in a similar manner.
socket which enable the axle to be steered and powered
at the same time.
b. Disassembly. Disassemble the front or rear
axle and ball joint assembly in numerical sequence as
283. Front and Rear Ball Joint Assembly Removal
illustrated on figure 83.
and Disassembly
Note.
a. Removal.
Disassemble the remaining ball joint
(1) Remove the wheel and hub (TM 53825-213-20).
assemblies in a similar manner.
(2) Remove the air brake chamber (TM 5-3825-
21320).
284.
Front and Rear Ball Joint Suspension
Assembly Cleaning, Inspection, and Repair
(3) Remove the service brake and slack adjuster
assembly (par. 291).
(4) Remove the tie-rod steering cylinder and control
a. Cleaning.
valve (TM 53825-21320).
(1) Clean all parts in an approved cleaning solvent
and dry thoroughly.
(5) Remove the front or rear skein and axle
assembly as instructed on figure 81.
(2) Remove hardened oil deposits from the socket
and ball.
b. Inspection and Repair.
Note.
Remove the rear steering lock
(1) Inspect the socket for breaks, wear, or other
mechanism before removing left rear
damage.
ball joint assembly.
(2) Inspect the ball for wear, breaks, or damage
bore.
(6) Remove the front or rear ball joint assembly as
instructed on figure 82.
202