TM 5-3825-213-35
Probable cause
Possible remedy
37. Insufficient Brakes or no Brakes
Defective check valve............... Replace defective check
Probable cause
Possible remedy
Grease-soaked or worn ............. Replace linings (pars.
linings.
Defective treadle valve ............. Repair treadle valve (pars.
40. Low Engine Speed at Converter Stall
Defective air compressor .......... Replace or repair air
Probable cause
Possible remedy
compressor (pars.
Defective converter .................. Repair or replace converter
Defective air chamber .............. Repair air chamber (para
Damaged stators ..................... Repair converter (pars.
38. Heater Inoperative
41. Transmission Input Shaft Does Not
Turn Freely By Hand
Probable cause
Possible remedy
Defective fuel pump ................. Replace fuel pump (TM
Probable cause
Possible remedy
5-3825-213-20).
Range clutch binding ............... Repair torqmatic trans-
Heater fails to ignite - ................ Replace flame switch (pars.
55-57 and 59-61) and/or
Converter failure ...................... Repair converter (pars.
igniter (TM 5-3825-213-20).
Fuel regulator valve .................. Replace regulator valve
failure.
42. High Engine Speed at Converter Stall
Power relay failure ................... Replace relay (pars. 55-57
and 59-61).
Probable cause
Possible remedy
Defective heater ....................... Replace or repair heater
Defective converter .................. Repair converter (pars.
Torqmatic transmission ............ Replace clutches (pars.
39. Low Converter Charging Pressure
clutch slippage.
Probable cause
Possible remedy
43. No Power Transmitted in Any Range
Defective oil pump ................... Repair or replace oil pump
(Torqmatic Transmission)
Defective selector valve............ Replace defective selector
Probable cause
Possible remedy
valve (TM 5-3825213-
Low clutch pressure ................. Repair oil pump (pars.
20).
Converter failure ...................... Repair converter (pars.
Section III. RADIO INTERFERENCE SUPPRESSION
44. General
Disassemble the generator
b. Disassembly.
Refer to TM 11-483 for definitions, purpose,
voltage regulator by disassembling the generator
sources, and methods to attain proper suppression.
voltage regulator cover assembly (fig. 1), and box
Refer to TM 5-3825-213-20 for location, description, and
replacement of primary radio suppression components.
These assemblies comprise the generator voltage
The generator regulator has capacitors contained within
regulator, and are disassembled in the numerical
the base that are to be replaced upon disassembly of
sequence shown in the respective illustrations.
the regulator.
Reassemble the generator
c. Reassembly.
voltage regulator in the reverse order of numerical
45. Generator Voltage Regulator
sequence as illustrated on figures 1, 2, and 3.
d. Installation.
Install the generator voltage
Remove the generator voltage
a. Removal.
regulator (TM 5-3825-213-20)
regulator (TM 5-3825-213-20).
30