TM 5-3825-213-35
1
Screw, cap, 3/816 x 1 1/4 in. (2 rqr)
5
Valve
2
Washer, lock, 3/8 in. (2 rqr)
6
Spring
3
Manifold
7
Pin, straight headless
4
Gasket
A. Manifold assembly
1
Screw, cap, 1/213 x 3 1/4 in. (4 rqr)
8
Pin, straight headless
2
Washer, lock, 1/2 in. (4 rqr)
9
Ball
3
Housing
10
Valve
4
Housing gasket
11
Oil seal
5
Cap
12
Ball
6
PREFORMED packing
13
Spring
7
Spring
B. Selector valve.
1
Screw, cap, 1/213 x 1 1/4
6 Screw, cap, 1/213 x 3 (6 rqr)
2
Washer, lock, special
7 Washer, lock, 1/2 in. (6 rqr)
3
Cap, dust
8 Retainer, bearing
4
Washer, flat, special
9 Gasket
5
Driving flange, output
10 Bearing
C. Retainer group.
1
Ring, retaining
5 Cover
2
Ring, retaining
6 Plug, pipe
3
Screw, cap, 1/2-13 x 1 1/2 in. (16 rqr)
7 Gasket
4
Washer, lock, 1/2 in. (16 rqr)
8 Bearing
D. Transmission front cover.
1
Screw, cap, 5/16-18 x 7/8 in. (2 rqr)
4 Gasket
2
Washer, lock, 5/16 in. (2 rqr)
5 Plug, pipe
3
Cover
6 Housing
E. Cover and plug.
Figure 76-Continued.
parts. Refer to table III, torqmatic transmission
268. Torqmatic Transmission Assembly Cleaning,
replacement standards, for maximum variations
Inspection, and Repair
from the original parts dimensions at which the
a. Cleaning. Clean all parts with an approved
transmission can be expected to function
cleaning solvent and dry thoroughly.
satisfactorily.
b. Inspection and Repair.
(1) Inspect all splined shafts and bearings surfaces
269.
Torqmatic
Transmission
Assembly
for wear, distortion, and chipped or broken
Reassembly and Installation
splines.
Reassemble the torqmatic
a. Reassembly.
(2) Replace all performed packing and gaskets.
transmission assembly in the reverse of numerical
(3) Inspect all springs for wear and distortion.
sequence illustrated on figure 76.
Replace as necessary.
b. Installation. Install the torqmatic transmission
(4) Inspect all gears for wear, chipped, cracked, or
assembly (par. 51).
broken teeth. Replace as necessary.
(5) Inspect -all other parts for defective condition.
Replace or repair worn, damaged, or defective
183