TM 5-3825-213-35
1
Screw, cap, -28 x 1 in.
11
Nut, 3/8-24 (2 rqr)
2
Washer, flat, in.
12
Washer, lock, 3/8 in. (2 rqr)
3
Nut, -28
13
Screw, cap, 3/8-24 x 1 in. (2 rqr)
4
Washer, lock, in.
14
Washer, flat, 3/8 in. (2 rqr)
5
Bracket
15
Brace
6
Screw, cap, -20 x 1- in. (4 rqr)
16
Screw, cap, -28 x in. (2 rqr)
7
Washer, flat, in. (4 rqr)
17
Nut, -28 (2 rqr)
8
Nut, -20 (4 rqr)
18
Washer, lock (2 rqr)
9
Washer, lock, in. (4 rqr)
19
Cover
10
Support
20
Turret housing
B. Turntable frame.
Figure 38. Continued.
Section IV. SNOW CHUTE GEARBOX ASSEMBLY
156.
General
158.
Snow Chute Gearbox Assembly Cleaning,
Inspection, and Repair
The snow chute gearbox assembly driven by the
hydraulic motor rotates the turntable by a chain drive.
Cleaning. Clean all parts in an approved
a.
The gearbox assembly is a reduction type.
cleaning solvent and dry thoroughly. Remove gasket
residue from mating surfaces.
157.
Snow Chute Gearbox Assembly Removal and
Inspection and Repair. Inspect all parts for
b.
Disassembly
wear, scoring, breaks, or other damage. Repair and
replace defective parts as necessary.
Removal. Remove the snow chute gearbox
a.
assembly (TM 5-3825-213-20).
159.
Snow Chute Gearbox Assembly Reassembly
Disassembly. Disassemble the snow chute
b.
and Installation
gearbox assembly in numerical sequence as illustrated
on figure 39.
Reassembly. Reassemble the snow chute
a.
gearbox assembly in reverse of numerical sequence
illustrated on figure 39.
Installation. Install the snow chute gearbox
b.
assembly (TM 5-3825-213-20).
105