TM 5-3825-213-35
Section III. SNOW CHUTE TURNTABLE ASSEMBLY
152.
General
154.
Snow Chute Turntable Assembly Cleaning,
Inspection, and Repair
The snow chute turntable assembly is the base for
the snow chute trough. The table is chain-driven from
Cleaning. Clean all parts in an approved
a.
the gearbox which in turn rotates the snow chute trough
cleaning solvent and dry thoroughly.
to desired working position.
Inspection and Repair. Inspect all parts for
b.
wear, breaks, or other damage. Repair or replace
153.
Snow Chute Turntable Assembly Removal
defective parts as necessary.
and Disassembly
155.
Snow Chute Turntable Assembly Reassembly
a.
Removal.
and Installation
(1) Remove the snow chute trough (TM 5-
3825-213-20).
Reassembly. Reassemble the snow chute
a.
turntable assembly in the reverse of numerical
(2) Remove the hydraulic motor, throttle
sequence illustrated on figure 38.
valve, gearbox, and drive chain (TM 5-
3825-213-20).
b.
Installation.
(3) Remove the snow chute turntable
(1) Install the snow chute turntable
assembly as instructed on figure 37.
assembly as instructed on figure 37.
Disassembly. Disassemble the snow chute
b.
(2) Install the gear box, hydraulic motor,
turntable assembly in numerical sequence as illustrated
throttle control valve, and drive chain
on figure 38.
(TM 5-3825-213-20).
(3) Install the snow chute trough (TM 5-
3825-213-20).
100