TM 5-3825-213-35
23
Ring, retaining
31
Bearing
24
Ring, retaining
32
Pin, straight headless
25
Gear
33
Pin, straight headless
26
Key
34
Bearing
27
Seal
35
Bearing
28
Seal seat
36
Pin, straight headless
29
Bearing
37
Pin, straight headless
30
Bearing
38
Housing.
Figure 20-Continued
101. Snowplow
Hydraulic
Pump
Assembly
and nicks on the machined mating
surfaces of the housing, cover, and
Reassembly and Installation
adapter with a suitable stone or fine mill
file.
a. Reassembly.
Reassemble the snowplow
(2) Inspect gears and housing for wear and
hydraulic pump assembly in reverse of numerical
measure housing width to gear width. If
sequence illustrated on figure 20.
the housing width is 0.002 inch greater
than gear width, both wear plates should
b. Installation.
Install the snowplow hydraulic
be replaced.
pump assembly (TM 5-3825-213-20).
Section VI. SNOW CHUTE HYDRAULIC MOTOR ASSEMBLY
102. General
Caution
The snow chute hydraulic motor assembly,
Do not use compressed air near
connected integrally with the snow chute turntable
exposed parts because of dirt and
gearbox and throttle valve, rotates the gearbox, turning
water in the air system.
the snow chute to the desired operating position.
b. Inspection and Repair. Inspect all parts for
103. Snow Chute Hydraulic
Motor
Assembly
wear, breaks, burrs, or scoring. Repair or replace
Removal and Disassembly
defective parts as necessary.
a. Removal. Remove the snow chute hydraulic
105. Snow Chute Hydraulic Motor
Assembly
motor assembly (TM 53825213-20).
Reassembly and Installation
b. Disassembly.
Disassemble the snow chute
a. Reassembly.
Reassemble the snow chute
hydraulic motor assembly in numerical sequence as
hydraulic motor assembly in reverse of numerical
illustrated on figure 21.
sequence illustrated on figure 21.
104. Snow Chute Hydraulic Motor
Assembly
b. Installation. Install the snow chute hydraulic
Cleaning, Inspection and Repair
motor assembly (TM 5-3825213-20).
a. Cleaning.
Clean all parts in an approved
solvent and dry thoroughly.
69