TM 5-3825-213-35
wear, scoring, or other damage.
Repair or replace
Caution
defective parts as necessary.
Be sure work area is free of dust and
dirt.
These elements can create
serious malfunction to the plow
93.
Snow Chute Hydraulic Lift Cylinder Assembly
hydraulic system.
Reassembly and Installation
Caution
a. Reassembly.
Reassemble the snow chute
Do not use compressed air near
hydraulic lift cylinder assembly in reverse of numerical
exposed parts because of dirt and
sequence illustrated on figure 19.
water in the air system.
b. Installation. Install the snow chute hydraulic lift
b. Inspection and Repair.
Inspect all parts for
cylinder assembly (TM 5-3825213-20).
Section IV. SNOWPLOW HYDRAULIC OIL RESERVOIR
94.
General
(2) Inspect the reservoir for cracks, breaks, or
any other visible damage.
The snowplow hydraulic reservoir is located inside
the carrier engine hood next to the steering hydraulic
Caution
system reservoir. The tank is of welded sheet metal
Be sure reservoir is free of dirt, as
construction.
dirt can create a serious malfunction
of the plow hydraulic system.
95.
Snowplow Hydraulic Oil Reservoir Removal
b. Testing and Repair. Seal all openings except
Remove the snowplow hydraulic oil reservoir (TM
one and apply 25 psi air pressure. Note any leaks that
5-3825-213-20).
appear, clean surface, and weld the reservoir.
96.
Snowplow Hydraulic Oil Reservoir Cleaning,
97.
Snowplow Hydraulic Oil Reservoir Installation
Inspection, Test, and Repair
Install the snowplow hydraulic oil reservoir (TM 5-
a. Cleaning and Inspection.
3825-213-20).
(1) Clean the reservoir with an approved
cleaning solvent.
Section V. SNOWPLOW HYDRAULIC PUMP ASSEMBLY
98.
General
100. Snowplow
Hydraulic
Pump
Assembly
Cleaning, Inspection, and Repair
The snowplow hydraulic pump assembly, mounted
on the carrier engine, is driven by the accessory drive.
a. Cleaning.
Clean all parts in an approved
The pump supplies force for the hydraulic system which
cleaning solvent and remove foreign matter from
operates three hydraulic cylinders and a motor to rotate
passages.
the snowplow chute. The pump is a gear-type pump.
Caution
99.
Snowplow Hydraulic Pump Assembly Removal
Be sure work area is free of dust and
and Disassembly
dirt. These elements can create a
serious malfunction to the plow
hydraulic system.
a. Removal.
Remove the snowplow hydraulic
pump assembly (TM 5-3825-213-20).
Caution
Do not use compressed air near
b. Disassembly.
Disassemble the snowplow
exposed parts because of moisture
hydraulic pump assembly in numerical sequence as
in the air system.
illustrated on figure 20.
b. Inspection and Repair.
(1) Inspect the pump for wear, burrs, nicks, or
other damage. Remove burrs
67
