TM 5-3825-213-35
CHAPTER 5
SNOWPLOW HYDRAULIC SYSTEM
Section I. SNOWPLOW HYDRAULIC LIFT CYLINDER ASSEMBLY
82.
General
Caution
Be sure work area is free of dust and
The snowplow hydraulic lift cylinder assembly is a
dirt.
Dust particles and dirt can
single-acting cylinder mounted integrally with the push
create a serious malfunction in the
frame. It is controlled by the operator from the manifold
plow hydraulic system.
valve mounted in the cab.
Caution
83.
Snowplow Hydraulic Lift Cylinder Assembly
Do not use compressed air near
Removal and Disassembly
exposed parts because of moisture
in air system.
a. Removal.
(1) Disconnect the hydraulic lines (TM 5-
b. Inspection and Repair. Inspect all parts for
3825213-10).
wear, scoring, or other damage. Repair or replace
(2) Remove the plow assembly (TM 53825-
defective parts as necessary.
213-10) .
(3) Remove the hydraulic lift cylinder
85.
Snowplow Hydraulic Lift Cylinder Assembly
assembly as instructed on figure 16.
Reassembly and Installation
b. Disassembly.
Disassemble the snowplow
hydraulic lift cylinder assembly in numerical sequence
a. Reassembly.
Reassemble the snowplow
as illustrated on figure 17.
hydraulic lift cylinder assembly in reverse numerical
sequence illustrated on figure 17.
84.
Snowplow Hydraulic Lift Cylinder Assembly
Cleaning, Inspection and Repair
b. Installation.
(1) Install the snowplow hydraulic lift cylinder
a. Cleaning.
Clean all parts in an approved
assembly as illustrated on figure 16.
cleaning solvent and remove all foreign matter from
(2) Install the plow assembly (TM 5-3825-
passages.
213-10).
(3) Connect the hydraulic lines (TM 5-3825-
213-10).
61