TM 5-3825-213-35
1
Pin, cotter (2 rqr)
16 Snap ring (2 rqr)
2
Nut, special (2 rqr)
17 Scraper (2 rqr)
3
Pin, cotter (2 rqr)
18 Wiper ring (2 rqr)
4
Nut, special (2 rqr)
19 Retainer (2 rqr)
5
Cylinder (2 rqr)
20 Washer (2 rqr)
6
Cover (2 rqr)
21 Seal (2 rqr)
7
Cover (2 rqr)
22 Seal (2 rqr)
8
Nut, 3/8-24 (2 rqr)
23 Seal (2 rqr)
9
Washer, lock, 3/8 in. (2 rqr)
24 Seal (2 rqr)
10
Screw, cap, 3/8-24 x 2-3/4 in., special (2 rqr)
25 Seal (2 rqr)
11
Stud ball (2 rqr)
26 Bolt, machine, 3/8-24 x 2 1/2 in. (8 rqr)
12
Nut, 3/8-24 (2 rqr)
27 Cap end (2 rqr)
13
Washer, lock, 3/8 in. (2 rqr)
28 O-ring (2 rqr)
14
Screw, cap, 3/8-24 x 1 3/4 in. (2 rqr)
29 O-ring (2 rqr)
15
Stud ball (2 rqr)
Figure 13-Continued.
Section III. FRONT STEERING CONTROL VALVE ASSEMBLY
70. General
b. Inspection and Repair. Inspect all parts for
wear, scoring, or other damage; repair or replace
The front steering control is connected to the
defective parts as necessary.
steering gearbox pitman arm and brake air chamber
support arm. Hydraulic pressure from the control valve
Note
when the steering wheel is turned operates the front
Do not attempt to touch up the valve
steering cylinder.
spool, this will result in malfunction
of the steering unit.
71. Front Steering Control Valve Assembly Removal
and Disassembly
73.
Front Steering Control Valve
Assembly
Reassembly and Installation
a. Removal. Remove the front steering control
valve assembly (TM 5-825-213-20).
a. Reassembly. Reassemble the front steering
control valve assembly in the reverse of numerical
b. Disassembly. Disassemble the front steering
sequence illustrated on figure 14.
control valve assembly in numerical sequence as
illustrated on figure 14.
Note
Immerse the parts in clean hydraulic
72.
Front Steering Control Valve
Assembly
fluid to facilitate assembly.
Cleaning, Inspection, and Repair
b. Installation. Install the front steering control
a. Cleaning.
Clean all parts in an approved
valve assembly (TM 5-3825-213-20).
cleaning solvent and remove foreign matter from
passages.
55