TM 5-3825-213-20
CHAPTER 1
INTRODUCTION
Section I. GENERAL
d. Report all deficiencies in this manual on DA
1. Scope
Form 2028. Submit recommendations for changes,
a. This manual is published for the use of the
additions, or deletions to the Commanding Officer, U.S.
personnel to whom the FWD Model S-349-V Snow
Army Engineer Maintenance Center, Corps of Engineers,
Removal Unit is issued. It contains information on
P.O.
Box 119, Columbus 16, Ohio.
Direct
organizational maintenance of the equipment, its
communication is authorized.
accessories, and auxiliaries, and also includes
e. Report unsatisfactory equipment perfor-
instructions for shipment and limited storage.
mance and suggestions for equipment improvement as
b. Appendix I contains a list of publications
specified in AR 700-38.
applicable to this manual. Appendix II contains the
maintenance allocation chart.
The organizational
2. Record and Report Forms
maintenance repair parts and special tool lists are
For record and report forms applicable to
contained in TM 5-3825-213-20P.
c. Numbers in parentheses on illustrations
organizational maintenance, refer to TM 5-505.
indicate quantity. Numbers preceding nomenclature
callouts on illustrations indicate the preferred
Note. Applicable forms, excluding standard
maintenance
sequence.
Form 46 which is carried by the operator, shall be
kept in a canvas bag mounted on the equipment.
Section II. DESCRIPTION AND DATA
(3) Rectifier plate. The rectifier plate is
3. Description
located on the rectifier housing and
TM
5-3825-213-10
provides
a
general
shows the make, type, voltage, and
description of the snow removal unit;
specific and
amperage.
detailed descriptions of the components
of the snow
(4) Fuel pump. The fuel pump data decal
removal unit are provided in the applicable
maintenance
is located on the fuel pump housing
paragraphs of this manual.
shows the name of the manufacturer
and type of pump.
4. Identification and Tabulated Data
(5) Air cleaner plate. The air cleaner plate
a. Identification. Descriptions and locations of
is located on the air cleaner housing
major identification plates on the snow removal unit are
and shows the make, type, and serial
listed in TM 5-3825-213-10. Thirty-two components of
number.
the unit carry identification and descriptive data in either
(6) Governor.
The governor data is
plate or decal form.
stamped on the housing and shows
(1) Starter motor plate. Located on the
name of the manufacturer, model, and
starter housing and shows the make,
serial number.
model, serial number, and voltage.
(7) Carburetor plate. The carburetor data
(2) Alternator plate. The alternator plate
plate is located on the top cover of the
is located on the alternator housing
and shows the make, model, serial
number, type, and voltage.
3
