TM 5-3825-213-35
1
Ring, retaining
16
Valve
2
Screen
17
Gasket
3
Screw, cap, 1/4-20 x 3/4 in. (4 rqr)
18
Spring
4
Washer lock, 1/4 in. (4 rqr)
19
Valve
5
Screw, cap, 1/4-20 x 1 7/16 in. (2 rqr)
20
Screw, machine, 3/8-24 x 1 in. (4 rqr)
6
Washer, lock, 1/4 in. (2 rqr)
21
Gasket
7
Body
22
Air dome
8
Gasket
23
Elbow
9
Nut, 10-32
24
Adapter
10
Valve
25
Screw, machine, 1/4-20 x 1 in. (6 rqr)
11
Spring
26
Washer, lock, 1/4 in. (6 rqr)
12
Plunger
27
Plug, pipe, 3/8 in.
13
Preformed packing
28
Gasket
14
Adapter, male
29
Reservoir
16
Cap and dipstick
C. Air dome and reservoir.
Figure 23. - Continued.
Section II. MOISTURE EJECTOR VALVE ASSEMBLY
112.
Moisture Elector Valve Assembly Cleaning,
110. General
Injection, and Repair
The moisture ejector valve is mounted beneath the
cab on the carrier frame. It is located between the air
a. Cleaning. Clean all parts with an approved
reservoir tanks and the brake treadle valve. Air from
cleaning solvent and dry thoroughly.
the air reservoir tanks passes through the moisture
b. Inspection and Repair. Inspect all -parts for
ejector valve which is designed to purge the system of
defective conditions. Replace or repair worn, damaged,
moisture and assure proper operation of the brake
or defective parts. All seals and rotor blade springs
system.
should be replaced when reassembling.
111. Moisture Ejector Valve Assembly Removal and
113. Moisture Ejector Valve Assembly Reassembly
Disassembly
and Installation
a. Removal. Remove the moisture ejector valve
a. Reassembly. Reassemble the moisture ejector
assembly (TM 5-3825-213-20).
valve assembly in the reverse of numerical sequence
b. Disassembly. Disassemble the moisture ejector
illustrated on figure 24.
valve assembly in numerical sequence as illustrated on
b. Installation. Install the moisture ejector valve
assembly (TM 5-3825-213-20).
76
