TM 5-3825-213-10
C. Lifting chain installation.
Figure 5. Continued.
lever (fig. 6) in CHUTE position,
Note
move snow chute and fan blower
If it is necessary to operate the snow
control lever to CHUTE DOWN
removal unit with the fan blower
position.
housing in left side spreading
(e) Control the snow direction chute
position, report this condition to
rotation with the chute turn control
organizational maintenance.
lever as illustrated in figure 6.
(f) stop carrier (fig. 17).
(c)
Stop carrier engine (fig. 13).
(2) Spreading position.
(a) Start carrier (fig. 16).
10. Movement to New Worksite
(b) Move selector valve control lever
(fig. 6), to FAN BLOWER position
a.
Securing for Movement.
and move snow chute and fan
(1) Start carrier engine (fig. 12).
blower control lever as necessary
to put fan blower housing in the
Note
desired spreading angle as
Be sure plow clutch is disengaged
illustrated in figure 9.
and all motion of plow is stopped.
Caution
(2) Remove the plow safety pins (fig. 5).
Before attempting to use the fan
(3) Raise plow assembly to its highest
blower
housing
in
spreading
position (fig. 6).
position remove the stop rod from
(4) Install and secure the plow safety pins in
the upper right-hand side of the fan
the lower holes of the plow carrier track
blower housing.
and guide rails (fig. 5).
Caution
Do not operate snowplow in the
transport position.
20