TM 5-3825-213-10
Lubricating oil:
Stroke .................................4-7/8 in.
Crankcase.....................18 qt
Cycle ..................................4
Oil filter assembly .........2 qt
Displacement ......................884 cu. in. (cubic inch) (es)
Coolant ..............................60 qt
Governed speed:
No load ........................2,850 rpm
(c) Steering.
Full load........................2,600 rpm
Gearcase ............................1 qt
Low idle ........................500 rpm
Power steering ....................9 qt
Maximum torque .................1,800 rpm 780 ft-lb (foot-
(d) Transmis-
pound) (s)
sion and
Compression ratio ..............7.6:1
torque con-
Firing order .........................1-8-7-3-6-5-4-2
verter 49 qt
Fuel consumption rate.........36 gph (gallons per hour)
(e) Transfer
Batteries..............................4 (12 volts each) (common
case. 5 1/2 qt
power source with plow
(f) Differential.
engine)
Rear ...................................7 1/2 qt
Electrical system ................24-volt
Front ..................................7 1/2 qt
(2) Plow engine.
(g) Differential
Manufacturer.......................Waukesha Motor Company
lock.
3/4 qt
Model ..................................TH 884
(h) Plow.
Type....................................Industrial, V-Block, Mili-
tary Standard, Gasoline
Hydraulic reservoir ..............34 qt
Horsepower .........................330 at 2,600 rpm
Plow transmission ...............8 qt
Cylinders.............................8
Plow fan gearcase...............2 qt
Bore ...................................5-3/8 in
Auger drive chain case........1 qt
Stroke ................................4-7/8 in.
(6) Dimensions and weights.
Cycle ..................................4
(a) Carrier assembly.
Displacement ......................884 cu. in.
Overall length* ....................329 in.
Governed speed:
Overall width (carrier) .........96 in.
No load ........................2,850 rph
Overall width with plow .......102 in.
Full load .......................2,600 rpm
Overall height ....................128 in.
Low idle ........................500 rpm
Shipping tonnage ................49.2 tons
Maximum torque .................At 1,800 rpm 780 ft-lb
Shipping weight...................31,695 lb
Compression ratio ..............7.6:1
Shipping cubage* ................2,322 cu ft (cubic foot)
Firing order .........................1-8-7-3-6-5-4-2
(feet)
Fuel consumption rate.........36 gph
*Denotes total for carrier and plow assemblies.
Electrical system ................24-volt
(b) Plow assembly.
(3) Carrier assembly.
Overall width.......................102 in.
Manufacturer.......................Four Wheel Drive Auto Co.
Overall length ....................52 in.
Model ..................................502300
Overall height (plow
115 in.
(4) Plow assembly.
down chute lowered)
Manufacturer ......................Klauser Manufacturing Co.
Shipping tonnage ................2.17
Model .................................TU3
(7) Maintenance and operating supplies.
Serial number .....................2581
The supplies necessary for maintain-
Capacity .............................1,500 tons per hour
ing and operating the snow removal
(5) Capacities.
unit are listed in table 1.
(a) Carrier engine.
5. Difference in Modes
Fuel tank ............................150 gal (gallon) (s)
Lubricating oil:
This manual covers only the FWD Model S-349V Snow
Crankcase.....................18 qt (quart) (s)
Removal Unit. No known unit differences exist for the
Oil filter assembly .........2 qt
model covered by this manual.
Coolant ..............................104 qt
(b) Plow engine.
Fuel tank ............................150 gal
8
