TM 5-3825-213-10
CHAPTER 3
MAINTENANCE INSTRUCTIONS
Section I. OPERATOR'S TOOLS AND EQUIPMENT
35. Special Tools and Equipment
36. Basic Issue Tools and Equipment
No special tools or equipment are required by the
Tools and repair parts issued with or authorized for the
operator for the maintenance of this snow removal unit.
snow removal unit are listed in appendix II.
Section II. LUBRICATION
37. General Lubrication Information
c. Points of Application.
Follow the detailed
lubrication instructions given beneath each illustrated
lubrication instruction point. Always apply the lubricant
a. This section contains a reproduction of the
specified on the current lubrication order (LO 5-3825-
lubrication order (LO 5-3825-213-20) and lubrication
213-20).
instructions which are supplemental to, and not
specifically covered in the lubrication order.
b. The lubrication order shown in figure 25 is an
Caution
exact reproduction of the approved lubrication order for
Overlubrication may cause equipment
the snow removal unit. For the current lubrication order,
failure or damage to working parts.
always refer to DA Pam 310-4.
d. Oil Filter Assemblies Service. Service oil filter
assemblies as illustrated in figure 26.
38. Detailed Lubrication Information
e. Carrier and Plow Engine Crankcase Breather
a. Care of Lubricants. Replace covers on lubricant
Service. Service crankcase breather as illustrated in
containers after use and store in a clean dry place.
Keep all containers used in handling lubricating oil or
f. Torqmatic Transmission and Torque Converter
gasoline clean and ready for use.
Service. Service transmission and torque converter as
b. Cleaning. Use an approved cleaning solvent to
illustrated in figure 28.
clean all surfaces surrounding the point of application
g. Carrier and Plow Engine Crankcase Ventilation
before applying the lubricant.
Service. Service carrier and plow engine crankcase
ventilation as illustrated in figure 29.
71