TM 5-3825-213-35
CHAPTER 1
INTRODUCTION
Section I. GENERAL
Military Construction Supply Agency/U. S. Army Engineer
1. Scope
Maintenance Center, Corps of Engineers, ATTN:
a. These instructions are published for the use of
MCSDM, P. O. Box 119, Columbus 16, Ohio. Direct
field and depot maintenance personnel maintaining the
communication is authorized.
FWD Model S-349-V snow removal unit. They provide
information on the maintenance of the equipment which
is beyond the scope of the tools, equipment, personnel,
e. Report unsatisfactory equipment performance
or supplies normally available to using organizations.
and suggestions for equipment improvement as
specified in AR 700-38.
applicable to this manual. The Maintenance Allocation
2. Record and Report Forms
Chart is published in TM 5-3825-213-20. Field and
depot maintenance repair parts are listed in TM 5-3825-
For record and report forms applicable to field and depot
213-35P.
maintenance refer to TM 5-505.
Note.
c. Numbers in parentheses on illustrations indicate
Applicable forms, excluding standard
quantity. Numbers preceding nomenclature callouts on
Form 46 which is carried by the
illustrations indicate the preferred maintenance
operator, shall be kept in a canvas
sequence.
bag mounted on the equipment.
d. Report all deficiencies in this manual on DA
Form 2028. Submit recommendations for changes,
additions, or deletions to The Commanding General,
Section II. DESCRIPTION AND DATA
Piston displacement ........ 884 cu. in. (cubic inch) (es)
3. Description
Bore ................................ 5 3/8 in. (inch) (es)
A general description of the snow removal unit and
Stroke ............................. 4 7/8 in.
description of the identification and instruction plates,
Maximum torque at ......... 780 ft-lb (foot-pound) (s)
and information of the difference in models are
1,800 rpm (revolutions
contained in TM 5-3825-213-10.
A more detailed
per minute).
description of the components is contained in TM 5-
3825-213-20. The repair and maintenance instructions
rating at 2,600 rpm.
are described in appropriate sections of this manual.
Compression ratio ........... 7.6:1
Cylinder liners ................. Replacement wet-type
4. Tabulated Data
Piston pin type ................ Full floating
a. Engines Classification and Rating.
Valve type....................... Straight
Manufacturer................... Waukesha Motor Company
b. Engines Repair and Replacement Standards.
Model .............................. T-H884
Table I lists manufacturer's sizes, tolerances, desired
Type................................ V8-w/valve in head, 4
clearances, and maximum allowable wear and
cycle
clearance.
Number of cylinders ........ 8
3